Standard Information | Dimensions(mm) | 29×23.5×16 | |
Excess weight ( g ) | ≈40g | ||
Make contact with Arrangement | 1A/1B | ||
Get in touch with Materials | AgSnOtwo | ||
Ambient Temperature | -40~+75ºC | ||
Vibration | ten~50Hz,one.5mm | ||
Shock | 1000m/s²,(100g) | ||
Requirements Data | Electricity Consumption | <3W | |
Operating Voltage | 10.five-16V | ||
Max. Switching Current | 100A | ||
Surge Current | 6000A/10ms | ||
Motor Resistance | 32(1±15%)Ω | ||
Speak to Voltage | <60mV | ||
Contact Resistance | ≤1.0mΩ | ||
Dielectric Toughness | Motor to Contact | >4000VAC,fifty/60Hz 1min | |
Throughout Open Speak to | >2000VAC,50/60Hz 1min | ||
CZPTal Lifestyle(120 cycles/H) | 10,000 (resistance five k + perceptual 5 k, co ϕ = .five) |
||
Mechanical Lifestyle(3600 cycles/H) | one hundred,000 | ||
Pulse Time | ≥60ms(Suggest 60ms~100ms) | ||
Choosing-up Time | ≤60ms | ||
Release Time | ≤60ms | ||
Insulation Resistance | >1000MΩ(500VDC) |
Cautions of Latching Relay:
1.Tips of relay’s enter
(one)Polarity-Please check the polarity inside of our complex specification, if single coil then”+ -” or “- +”are good,
you can adjust it by a single pulse.If double coil then it’s necessary to confirm “-+-” or “+-+”ahead of leaving the our factory.
(two)Driving-Please energize the relay at our recommend pulse width, rated voltage for reliable performance, if 1.5
times or 2 occasions of price or reduce driving situation plz verify with our engineer.
(three)Relays’contact standing may possibly be changed for the duration of transportation or installation owing to influence of exterior pressure,
for that reason you should reset to the required position.
two.Tips of relay’s output
(1)When choosing the relay with difficult relationship,you should steer clear of the exterior drive on load terminals throughout or right after
the installation.
(two)When the relay will be linked with screw or bolts to the relays’ terminals, plz make sure your relationship is
mounted and prevent relay from damages or other security difficulties owing to temp. Increase..
(3)The sampling signal wires of merchandise are restricted, remember to do not pull or torque throughout set up.